Product Description
Gorilla Contact Spray Adhesive Ultimate is an incredibly strong, permanent contact adhesive that resists heat and moisture. This formula has an aggressive tack that can be used on a variety of materials and surfaces, both indoor and out. The adjustable anti-clog nozzle is easy to use and offers 3 ways to spray web pattern, for a narrower or wider application. Bonds heavy duty fabric, car headliners, foam, rubber, felt, cork, ceramics, laminate, leather, metal, plastics, wood, canvas, & more!
Features & Benefits
- PERMANENT BOND – High Strength.
- WEB SPRAY.
- AGGRESSIVE TACK.
- LOW VOC – Meets CA CARB/OTC VOC requirements.
- 3 WAYS TO SPRAY – Adjustable nozzle.
- RESISTS HEAT & MOISTURE.
- MULTI-PURPOSE.
- BONDS: Rubber, Felt, Cork, Ceramics, Laminate, Leather, Metal, Plastics*, Wood, Canvas & More.
Country of Origin: United States.
Application Instructions
All surfaces should be clean and free of dirt, grease and oil. Protect surrounding areas from overspray to avoid residual adhesive.
Shake can well before using.
Adjust spray pattern width by turning spray tip to desired setting (Low-Med-High).
Hold can in a vertical position 6 to 8 inches away from surfaces to be bonded and apply a uniform coat. Allow to dry to tack (approximately 1 minute) and press surfaces firmly together. Note: material is not repositionable.
For Maximum Bond Strength: Spray both surfaces to be joined with multiple coats of adhesive and dry to tack (1-2 minutes, depending on thickness) before bonding. Apply firm pressure when joining. Note: porous surfaces will require more than one coat.
To avoid possible clogging, turn can away from body, invert and spray a short jet to clear valve and spray tip.
Note: If nozzle experiences a clog, actuate rapid short bursts until cleared.
Not recommended for polystyrene foam and unsupported vinyl. Certain plastics can experience bond failure due to plasticizer migration. Heat and humidity can affect dry time.Warning: This product can expose you to chemicals including , which is [are] known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov/.
* Multiple cases may be shipped per package in order to minimize the charge for shipping.
Technical Information
Gorilla Contact Spray Adhesive Ultimate
- Standards Met: Meets CA CARB/OTC VOC requirements
- Service/Operating Temperature: 32°F to 180°F
- Application Temperature: 50°F to 90°F
- Indoor/Outdoor: Yes – Gorilla has some water resistance capabilities but should not be used where finished product could be immersed/submerged in water (example of an outdoor application: wreath on a front door).
- Moisture Resistant: Yes
- Paintable: Acrylic paints will cure, but can be scratched off; spray paints cover up well, minimal susceptibility to scratch-off; oil-based paint will remain tacky but does not scratch off (not recommended for oil-based paints)
- Sandable: Not easily sanded
- Stainable: Oil stained will remain tacky
- Cured Color: Light yellow when applied
- Gap Filling: No
- Storage: Between 32°F (0°C) and 120°F (48°C) – upper limit is extremely important due to flammability concerns
- Country of Origin: United States
Note: Specifications are those given by manufacturers and are not tested for accuracy.